top_pattern_L2
top_pattern_R2

for iOS

Download

Click here to Download

License Information

How to use

ID Confirmation / ID and Password Modification

(1) Navigate to "My Page" by clicking the "Person Icon" in the top right corner.

(2) Your ID will be displayed as "xxx-xxxx," with 3 characters followed by a hyphen and 4 characters.
You can change your ID by clicking "Change ID."
Please be aware that once changed, your ID cannot be reverted to its original state.
You can also change your password by clicking "Password Change." If you prefer not to use a password, please leave it blank.

CAMERA

(1)Select the 'CAMERA' icon.
(2)Enter the ID displayed on the web page and the password you set yourself. (Blank if password is not set)
(3)Set each channel for video, audio, and bit rate control (*1). (0-255ch)
 *If set to 0ch, it will not be encoded. Use when you want to send only a part of the video.
(4)Select the video/audio bit rate and video format to be sent.
(5)Start/Stop the transmission.
(6)Selects a camera.
(7)Slide to zoom.
(8)Select the audio source.
(9)This is the level meter for the input audio.
(10)Switches between manual and automatic focus.


*1 Specify the channel for receiving bitrate control.
Set the same channel as specified in macOS>Player>(13)Quality.

How to use the Control Quality function

TALLY

(1)Select the 'TALLY' icon.
(2)Enter your ID and password as specified by the sender. (Leave blank if no password is set)
(3)Set the channel to match the sender. (1-255ch)
(4)Start/Stop the reception.

*Tally signals can only be transmitted from the plugin for TouchDesigner.
 By sending a numerical value between 0 and 3, the tally signal can be received as 0: OFF / 1: RED / 2: GREEN / 3: AMBER.

How to Use the Tally Function

CTRL

(1)Select the 'CTRL' icon.
(2)Enter your ID and password according to the sender. (Leave blank if no password is set)
(3)Set the channel to match the source of transmission.(1-255ch)
(4)Start/stop transmission.

*The current functionality is only available for reception in the TouchDesigner version.
 Data from the gyroscope and accelerometer built into the iOS device can be sent.
 Furthermore, if an iOS device is connected to a game controller via Bluetooth, its operation data can also be sent.

How to use the Control function

PLAYER

(1)Select the 'PLAYER' icon.
(2)Enter the ID and password corresponding to the sender. (Leave blank if the password is not set.)
(3)Set the video and audio channels to match the sender.
(4)Set the delay values for video and audio.
(5)Start/Stop the reception.

*Please be aware that the maximum resolution supported by the non-commercial version of TouchDesigner is 1280 x 720.If you receive video with a resolution higher than this maximum, it cannot be processed correctly.


・Outputting the screen to HDMI or AirPlay results in a clean feed with no buttons or status display.
・If the application screen is closed during playback in PLAYER, it will continue in Picture-in-Picture mode.
・Supports audio background playback.

Common to all apps


・The bit rate and delay value can be changed even during encoding.
・It is not possible to send signals from more than one terminal to the same receiving channel.
 The terminal sent first has priority, and for terminals sent later, exclusion control is activated and a ‘Previous stream exitst!’ error occurs.
 When the encoder is restarted, this error occurs if it is started without an interval, as the status before the stop remains.

control signal correspondence table